Greetings, I don't see anything out of the ordinary with this script around the point of failure. Do you know if there are any 3rd party enhancements on this system? Was this installation a clean install or are you using data that was converted/migrated from a previous version? While there should not be a W/O Module in Sage 100 Premium, check the SY_Module table to be sure that there isn't a W/O Module record. Also, check the MAS90 folder to make sure there isn't a WO folder. If all of that checks out OK, then you should open a case with Sage 100 Customer Support so that they can get copies of your script and data in order to try and duplicate the issue and figure out what is happening. Thank you, Kent
↧